Heres what the frame and skin looks like all painted purty like.

It's very difficult to rivet and buck the skin to the leading edge by yourself so I had to improvise using tape to hold it

upright as shown here.  Worked juss fine...

Almost looks like I squeezed them.

Installed the bracing on the right side.

Right side finished. Tried not to scratch my beautiful paint.

Didn't create any smileys.

They called out for 470 4-6's on these 7 rivets.  I don't think so Hoss!  That would look like dog poop.

I used small headed 426 4-6's instead.

I went ahead for a test fit at this point just to see how it still fit and as you can see it's fit went to Hell in a Handbasket.

Time to get out the BIG rubber mallet!  Who needs air vents when your Tip-up fits like this? 

Check back later for an unknown resolution......