I screwed up the last pair of outboard sub-panels.  If you look closely at the pics from 12-18-04.  Ole

Jeffie went ahead and riveted the seal support flush with the flange on the sub-panel.  After I noticed

I screwed that up I ordered another pair along with the seal support angle the week before Christmas

and finally got them!

Anyway... these are the new ones all primed, riveted and ready to go....

More primed parts of the sub-panel.

I was able to fix this part.  I had done the same thing here on the seal support.

Riveted on the channel.

Flush riveted the outer sub-panel where the hinge block goes.