I had installed my Oil Cooler and therefore was able to make my hoses.

I had to add these extensions to the front sides for an attach point.  I could just make a new baffling side but maybe later...

I will use a #8 screw and nut here.

With this cleco in here this inlet ramp is rock solid !

Also added one to the left side.

Wrapped up my oil temp sensor wire and added my Deans connector.

More wires will be entering this hole and then I will silicone it completely sealed.  All my wires will have a disconnect here so I can totally

remove my engine without much trouble.  I will be painting before this thing flys.