Pulled off the Vans gascolator and am replacing it with the Andair unit.

This unit is not only more compact but it is lighter and easier to remove the bottom bowl.  Hate to say it but its worth the extra measly

$35 for this unit.

I wanted to use the same mounting as what I had already drilled so I whipped up this bracket made of angle to mount it.

Drilled the hole for the 90 degree primer fitting.

Here is it temporarily mounted.  As you can see it has lots more clearance around it.  I'll be adding an extension to the bottom drain

so that I may access from it outside of the cowl.

Here's the new Positech Oil Cooler from Vans.  The one I had was too large and just would not fit.  Sold it in a day so no losses there.

Got the shaft having gone with Spruces Throttle and Mixture cables. They did not come with the threaded sleeve shown here.

I got new ones from Vans and I am very pleased with these even more.

Kinda need the threaded sleeve and nuts here if you want to mount it.

I also got these cable end bearings from Vans for both cables.  Makes hooking them up a snap!

Also picked up this Tach cap from Vans.

This is also Vans Heat Muff assembly.  Very nice.